Curve interpolation with variable feedrate for surface requirement

Abstract

Finish machining of a curved surface is often carried out by an NC system with curve interpolation in the field. This function, called a NURBS interpolation, adopts a feedrate optimizing strategy based on both the geometrical information of the curved path and dynamic properties such as the curvature of the curve, the allowable acceleration and the time constant. However, in the case of a finish cut using a ball-end mill, the curve interpolator needs to take the machining process into account for improved surface roughness, while reducing the polishing time. This surface roughness on high-speed machining is theoretically defined by the feed per tooth and the pickfeed at the given radius of the tool. In this study, the effect of low machinability at the bottom of a tool on surface roughness is also considered. A curve interpolation algorithm is proposed for generating particular feedrate commands that are able to control the roughness of a curved surface. The simulation of the machined surface by the proposed algorithm was carried out, and experimental results are presented. A feedrate scheme that depends on the inclination angle has important potential application in part finishes consistent with prescribed surface roughness. The results show that the proposed algorithm is potentially useful for roughness-controlled machining of curved surface products.