The nozzle parts of solid rocket motors must endure both the internal pressure generated by high temperature exhaust gas and the mechanical load generated by steering operation. Therefore, the nozzle parts of solid rocket motors are fabricated with thick carbon fiber phenolic resin composites. When the thick-walled phenolic composite cylinder is cooled down from the curing temperature of about 155 degrees C to the room temperature, thermal residual stresses are created due to the anisotropic thermal deformation of the composite structure. In this paper, a smart cure method with cooling and reheating was developed to reduce residual stresses in thick-wound composite cylinders made of carbon phenolic woven composite. The optimal cure cycle was obtained to reduce the residual stresses without increasing processing time and applied to fabrication of the thick-walled composite cylinder. From the residual stresses measured by the radialcut-cylinder-bending method, it was found that the residual stresses were reduced 30% by using the smart cure method. (C) 2006 Elsevier Ltd. All rights reserved.