Browse "AE-Theses_Ph.D.(박사논문)" by Title 

Showing results 414 to 433 of 605

414
마이크로 연료 전지의 연료 개질을 위한 MEMS 촉매 반응기 = MEMS catalytic reactor for fuel reforming in micro fuel cell applicationslink

차홍석; Cha, Hong-Sseok; et al, 한국과학기술원, 2007

415
마이크로 터빈 엔진의 적외선 신호 특성 및 감소 기술에 관한 연구 = Characterization and reduction of infrared signature of a micro turbine enginelink

구본찬; 백승욱; et al, 한국과학기술원, 2018

416
마찰 감쇠기가 있는 블레이드 디스크의 동적 특성에 관한 연구 = A study on dynamic characteristics of a bladed disk with friction damperslink

유재한; Yoo, Jae-Han; et al, 한국과학기술원, 2006

417
모멘텀 비를 변화한 다중 동축 선회 젯 분사기의 연소 특성에 관한 연구 = Combustion characteristics of multi-element swirl coaxial jet injectors under varying momentum ratioslink

소윤석; 권세진; et al, 한국과학기술원, 2022

418
모멘트 기반 질량추정을 이용한 고정익 무인항공기 초기 사이징 = Preliminary sizing of fixed-wing UAV using moment-based mass estimationlink

하현석; 안재명; et al, 한국과학기술원, 2022

419
모바일 연료전지 시스템용 메탄올-과산화수소 산화수증기개질의 특성 = Characteristics of $MeOH-H_2O_2$ oxidative steam reforming for mobile fuel cell applicationslink

박병섭; Park, Byeongseob; et al, 한국과학기술원, 2016

420
무산소 환경 NaBH4/H2O2 직접 연료전지의 친수성 전극 제작과 안정제 농도에 따른 장기 성능 = Hydrophilic electrode and effect of stabilizer concentration on long-term performance of direct NaBH4/H2O2 fuel cell for air independent propulsionlink

장보선; Jang, Bosun; et al, 한국과학기술원, 2015

421
무인기용 경량 PEM 연료전지의 마그네슘 분리판 제작 및 성능평가 = Fabrication and performance evaluation of magnesium bipolar plates of lightweight PEM fuel cell for UAVlink

박토순; Park, To-Soon; et al, 한국과학기술원, 2014

422
무인기용 액티브 전력제어장치 개발 및 성능 평가 = Development and performance evaluation of active power management system for UAV'slink

이보화; Lee, Bohwa; et al, 한국과학기술원, 2016

423
물-디젤 에멀젼 연료의 단일 액적 증발 및 연소 특성 연구 = Evaporation and combustion study of a single water-diesel emulsion dropletlink

원종한; 백승욱; et al, 한국과학기술원, 2019

424
반도체 웨이퍼상의 입자 침착속도의 측정 및 제어 = Measurement and control of particle deposition velocity on a semiconductor wafer surfacelink

배귀남; Bae, Gwi-Nam; et al, 한국과학기술원, 1994

425
반응표면 분석법을 이용한 후방 동체-핀 왜곡모형의 보정 = Optimal aft end distorted fin model using response surface methodlink

오세윤; Oh, Se-Yoon; et al, 한국과학기술원, 2009

426
벤츄리 스크러버 집진장치의 삼상 유동에 대한 수치 모델링과 성능해석 = Numerical modeling for performance analysis of three-phase flow in venturi scrubberlink

박순일; Pak, Sun-Il; et al, 한국과학기술원, 2005

427
병렬화된 직접모사법을 이용한 극음속 외부 대기와 측면 제트 상호 작용에 대한 연구 = Analysis of the interaction between hypersonic free stream and side jet flow using a parallel DSMC methodlink

김민규; Kim, Min-Gyu; et al, 한국과학기술원, 2005

428
보강된 복합적층 판넬의 좌굴 및 좌굴후 거동 = Buckling and postbuckling behavior of stiffened laminated composite panelslink

이인철; Lee, In-Cheol; et al, 한국과학기술원, 1995

429
복사 효과를 고려한 축 대칭 고체 로켓 모터의 점화 현상에 관한 수치적 연구 = A numerical simulation of axisymmetric solid rocket motor ignition transient with radiation effectlink

조인현; Cho, In-Hyun; et al, 한국과학기술원, 1997

430
복사와 대류에 의한 사각 밀폐공간내 고체연료의 점화에 관한 연구 = Analysis on the radiative and convective ignition of the solid fuel in a confined rectangular enclosurelink

김택영; Kim, Taik-Young; et al, 한국과학기술원, 1993

431
복사효과를 고려한 연속체 및 분자류 영역에서의 음파의 전파특성에 관한 연구 = Radiation-affected characteristics of sound wave propagation in continuum and molecular flow regimelink

박재현; Park, Jae-Hyun; et al, 한국과학기술원, 2002

432
복소 유전율 모델을 활용한 전자파 흡수 복합재료 적층판 설계 = Design of microwave absorbing composite laminates by using semi-empirical permittivity modelslink

김진봉; Kim, Jin-Bong; et al, 한국과학기술원, 2008

433
복잡한 3차원 압축성 유동문제를 위한 효율적인 비정렬 적응격자기법의 개발 = Development of an efficient unstructured adaptive mesh technique for the complicated three-dimensional compressible flow problemslink

김종관; Kim, Jong-Kwan; et al, 한국과학기술원, 1994

rss_1.0 rss_2.0 atom_1.0